Acrylic
Whirlpool Bathtubs:
Refinishing - Compounding - Polishing
|
We can restore a Whirpool or
Jacuzzi tub to like new condition buy
refinishing, compounding and polishing. |
|
| Why should I install a whirlpool
tub in my home? |
There are many good reasons. Some of the
most important are:
- Medical:
Hydrotherapy has been proven to be one of the best and most
effective forms of relief for certain medical conditions
such as muscle and joint pain, back and neck aches, sprains,
stiffness, and other minor injuries.
- Stress Relief:
Hydrotherapy massage is a fast and effective form
of stress relief that is readily available for everyone
in the family. The wide variety of jet options, lumbar massage
system, neck massage pillow, and air massage system offer
the ultimate flexibility in relief from stress and muscle
stiffness.
- Resale Value:
Studies have shown that a bathroom remodeling project that
features the addition of an acrylic whirlpool bath can increase
the resale value of your existing home by as much as $15,000
to $ 20,000 dollars. Luxury bathroom options are a highly
valued feature in today's housing market.
|
| Are whirlpool bath tubs safe?
|
Yes. They are every bit as safe as your standard
bathtub or shower. Unlike outdoor spas or hot tubs (which are
similar to swimming pools), your indoor whirlpool bathtub is
emptied after each use. There are no chemicals or stored water
involved. The entire unit, as well as each of the components
used in the production of it, are all NAHB tested and UL approved.
|
| Do I have room to install
one in my bathroom? |
Acrylic whirlpool bathtubs are offered in
numerous different shapes and sizes. There are models with integral
acrylic skirts and flanges. There are also sizes that will fit
into any corner. Also, just like a standard bathtub, they can
be used with or without a shower. All of the plumbing (including
the pump and optional upgrades) are installed under and within
the parameter of the tub so no remote component installations
are necessary.
|
| Are they hard to install?
|
Usually, they are manufactured with their
own pre-leveled installation base to sit directly on the floor.
No need to shim, level, or set in mortar. All of the power components
(pump motor, heater, optional on/off switch) are supplied with
a cord and plug. No need to wire - simply plug into a wall outlet.
All run on standard 110 volt power. There are no special electrical
requirements. Nor are there any additional plumbing needs.
|
| Are they expensive to operate? |
| No more than any other household major appliance.
The motor, heater, and any other options are standard 110 volt
so the average cost to operate your whirlpool is only pennies
a day. |
| request
a price quote |
|
